Hello,
Many of us face a lot of problem when we have to reinstall windows on our computer or laptop. First
thing we have to decide from where to install windows? The options available are DVD or USB Pendrive.
In the latest new netbooks, mostly there is no DVD drive. So if you want to install windows you have to
go with the other option, i.e. USB Pendrive. So here I give a brief and 100% tested tutorial on how to
create a Windows 7 Bootable USB Pendrive to install Windows 7 from USB Pendrive.
First thing, you should check whether your BIOS supports booting from USB. Most of the
computer/laptops support. But if your BIOS doesn’t, then sorry, you cannot boot from a USB Pendrive.
Second thing, you need another computer with Windows installed with a DVD drive, to copy its contents
later.
So let us start with the procedure now:
1) Run command prompt (cmd). This can be done by clicking start and typing typing cmd in Windows
7. In Windows Xp, click on start and then click on run. Type cmd and run. This will open the command
prompt which will look like this:
2) Then run diskpart utility from command prompt, by typing ‘diskpart’ on command prompt and
pressing enter. This will run the diskpart utility in a separate windows, which is shown in 2nd picture
below:
3) Now put in your pendrive in a USB port. Your pen drive must be
atleast 4 GB, 8 GB pendrive is best for this purpose. Now go back to the
diskpart console and type ‘listdisk’ and press enter. This will list
the various storage devices available. You can see the size column of
the disk and here we can see that ‘disk 2′ is our pen drive. Warning: In
your computer it may be some other number. In our case it is ‘disk 2′.
4) Then you have to type ‘select disk 2′ and press enter. Note: in
our case it is disk 2, in your case it may be disk 3, or disk 1 or any
other number. You can enter ‘detail disk’ to see the details of the disk
after selecting it to verify that you have selected the correct disk.
You can see these steps in the image below:
5) Then you have to run a series of commands. The commands to be run in the order are:
- clean
- create partition primary
- select partition 1
- active
- format fs=fat32
These steps are shown in the image below:
6) The format step will take some time. You can have a tea or coffee
in the meantime and come back. After the format is complete you have to
run ‘assign’ command. And after this you can exit diskpart utility by
entering the ‘exit’ command. The steps are shown below:
- assign
- exit
- The image below shows all the steps taken from the first step:
7) After the format is complete, put in your original Windows 7 DVD
in your DVD drive, or if you have an .iso image of the DVD, mount that
image using any virtual drive software like Power ISO.
- Now go to My Computer, and open the contents of DVD Drive. Press
‘ctrl+a’ to select all contents and copy all the contents by pressing
‘ctrl+c’.
- Now go back to My Computer and open the USB Drive and press ‘ctrl+v’ to paste all the contents of DVD into the USB Disk.
When the copy finishes, you are done just remove the USB Drive safely and use it to install Windows 7 in your computer/laptop.
